The corn thresher is mainly composed of a screen cover (ie, drum), a rotor, a feeding device, a frame, and other 5 parts. During work, corn is fed from the feed port, the seeds are separated by the screen hole, and the corn cob is The tail of the machine is discharged, and the corn silk and the skin are discharged from the tuyere. The use of corn thresher must be prepared in advance to avoid accidents.
Working principle of corn thresher
1. Components
The corn thresher is mainly composed of a screen cover (ie, drum), a rotor, a feeding device, a frame, and other 5 parts. The screen and the upper cover rotor form a threshing chamber. The rotor is the main working component. The threshing is done in the threshing room.
2. Working principle
The corn is fed from the feed inlet, the corn is impacted in the rotor and drum rotating at high speed, the grains are separated by the screen hole, the corn cob is discharged from the tail of the machine, and the corn silk and the skin are discharged from the tuyere. The feed inlet is located at the upper part of the upper cover of the machine. The corn cob enters the threshing chamber through the feed inlet. In the threshing chamber, the corn kernels fall off due to the impact of the rotor rotating at high speed, and are separated through the screen holes.
3. Matters needing attention
Before working on the thresher, it is necessary to educate the participants on the safe operation, carefully check whether the rotating parts are flexible, and whether the adjustment mechanism is normal. The gearing ratio is required to avoid excessive thresher speed and severe vibration, which may cause personal injury.
4. Maintenance instructions
After using the thresher, remove the dust and other debris attached to the machine in time, remove the loose screws, transmission belts, conveyor belts and chain belts. The oil stains on the transmission belts need to be cleaned with soapy water to dry and hang separately On the wall to prevent corrosion and aging.
No comments:
Post a Comment